Kenwood Chef Instructions page 11

To fit and use
your Splashguard
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside
of the mixer head
The hinged section should be positioned as
shown.
4 Insert required tool.
5 Lower the mixer head.
• During mixing, ingredients can be added
directly to the bowl via the hinged
section of the splashguard
• You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising the
mixer head and pushing it down.
until fully located.
6
.
7
Tool Adjustment
K-beater & Whisk
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
a suitable sized spanner:
TYPE KVC30 = 15mm
TYPE KVL40 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk and K-beater should be almost
touching the bottom of the bowl
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
shaft . To lower the tool closer to the
9
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
achieved tighten the nut securely.
• Note: Spanner shown is for illustration
purpose only.
Dough Tool
This tool is set at the factory and should
require no adjustment.
8
.
8