Technical Specification - Beamz Phantom 750 Mode D'emploi

TROUBLE SHOOTING
1. If the power indicator is off and the laser doesn't work, please check the power supply and the input.
2. In Stand-Alone operation, if the power supply indicator is ON and sound active indicator is OFF, but
the laser doesn't work.
A. The sound may be too small and cannot activate the laser running, please increase the music
volume or increase sound sensitivity on rear panel.
B. Please check if unit has been set up in slave mode, or DMX mode.
3. In Master-Slave operation, slave units don't running, please check as below.
A. Make sure there's only one master in the chain, and the others are set in slave mode.
B. Make sure to use a good quality power cable and XLR connector.
4. In DMX operation, the unit can't be controlled by the DMX console, but the DMX signal indicator is
flashing, please make sure the DMX console and unit have the same channel.
After trying the above solution you still cannot sort out the problem, please contact your dealer or our
company for service.

TECHNICAL SPECIFICATION

Ref.nr:
Laser Green
Laser Red
Laser Blue
Guaranteed laser power
Max. laser power
Scanner system
Class
Modes
Interface
Function
Rated voltage
Fuse
Rated power
Weight (per unit)
Dimensions per unit
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications
can be changed without prior notice.
Phantom 750
152.976
100mW @520nm
150mW @637nm
500mW @447nm
600mW
750mW
30K high speed optical
scanner
4
Sound Active, Auto run,
DMX512 (12 CH),
Master/slave mode, ILDA
3 pins XLR for DMX or
Maser-Slave linking, DB25
ILDA interface for PC
DMX, Auto, Sound active
and Master-Slave
AC110～240V 50/60Hz
T3A
150W
4.9Kg
250 x 235 x 172 mm
www.tronios.com
Copyright © 2015 by TRONIOS the Netherlands
Phantom 1250
152.973
200mW @520nm
300mW @637nm
750mW @447nm
1000mW
1250mW
30K high speed optical
scanner
4
Sound Active, Auto run,
DMX512 (12 CH),
Master/slave mode, ILDA
3 pins XLR for DMX or
Maser-Slave linking, DB25
ILDA interface for PC
DMX, Auto, Sound active
and Master-Slave
AC110～240V 50/60Hz
T3A
150W
5Kg
260 x 225 x 172 mm
Phantom 3000
152.970
600mW @520nm
800mW @637nm
1600mW @462nm
2500mW
3000mW
40K high speed optical
scanner
4
Sound Active, Auto run,
DMX512 (12 CH),
Master/slave mode, ILDA
3 pins XLR for DMX or
Maser-Slave linking, DB25
ILDA interface for PC
DMX, Auto, Sound active
and Master-Slave
AC110～240V 50/60Hz
T5A
150W
11.8Kg
275 x 320 x 252 mm
15