Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
All manuals and user guides at all-guides.com
· As additional safety measure, it is recommended that a tested residual current appliance
de
(RCD) with a residual operating current of not more than 30 mA be installed in the bathroom
circuit. Ask your electrician for advice.
en
· Disconnect from the mains before cleaning or servicing the appliance.
· Never use the appliance if it is defective, if it has fallen onto the floor or if the mains cable
fr
is damaged. A damaged mains cable may only be replaced with an original replacement
cable by an authorised Service Centre or another similarly qualified person, in order to avoid
hazards.
it
· Repairs may only be performed at an authorised Service Centre using original parts. Only
specialists properly trained in the handling of electrotechnical appliances may repair electrical
es
equipment.
· Only use accessories recommended by the manufacturer.
pt
· When disconnecting the appliance from the mains, never pull on the mains cable or on the
appliance itself.
nl
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a
handle.
sv
· Do not wind the mains cable around the appliance.
· Keep the mains cable and appliance away from hot surfaces.
· Make sure that the mains cable is not twisted or kinked when used and stored.
no
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
released.
fi
· Do not expose the appliance to temperatures below 0°C and above +40°C for any length of
time. Avoid direct exposure to sunlight.
tr
· The appliance is safety insulated and radio screened. It meets the requirements of EU
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
pl
2006/95/EC.
· We are not liable for damage caused as a result of improper use or failure to observe these
cs
operating instructions.
Operation
sk
· Unfold the base stand and place the appliance on a flat, smooth, non-heat-sensitive surface.
· Connect to the mains power supply.
hu
· Using the on/off switch (E), switch on the appliance (Fig. 1).
· Set the desired temperature (80°C – 210°C).
sl
The preset temperature is 180°C.
To increase the temperature, press the button (F).
ro
To reduce the temperature, press the button (G).
Note: The temperature can be adjusted by 5°C at a time by tapping on either of these but-
bg
tons. To adjust the temperature more quickly, hold down the appropriate button.
· The LCD display flashes three times when the temperature is set. Once the set operating
temperature has been reached, the LCD display shows the temperature. The LCD display
ru
flashes until the desired temperature has been reached. After the desired temperature has
been reached, the flashing stops.
uk
· After use, switch off the appliance with the on/off switch (Fig. 1). Hold the on/off switch to do
this. The LCD display must go out.
el
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
ar
8
Publicité
