Use Voice Command; Voice Command Training - Philips Digital Pocket Memo LFH 9600 Manuel De L'utilisateur

5.5

Use Voice Command

Voice Command allows to add keywords to
dictation files by speaking them.
D Note
The Voice Command feature must be enabled
with Philips SpeechExec or the software
application of your system integrator and the
proper configuration (keywords, codes to use)
and settings must have been transferred to the
Digital Pocket Memo. See
on page 19 for more information.
5.5.1

Voice command training

The voice recognition engine of the Digital
Pocket Memo must be trained to recognize your
voice and way of speaking. You can quickly train
the Digital Pocket Memo to recognize individual
numbers and letters of the alphabet, as well as
keywords. The training process takes only a few
minutes.
Follow these steps to train the Digital Pocket
Memo:
Press the
1 button
MENU
position to open the menu.
Press the + or – button
2
Setup menu item and press the
button .
3
Press the + or – button
3
Voice cmd traing menu item and press the
smart button
ENTER
D Note
The voice command setting must be acti-
vated in Philips SpeechExec or the software
User manual
Advanced configuration
while in the stop
1
to select the
2
smart
ENTER
to select the
2
.
3
application of your system integrator for this
option to appear in the menu.
The first keyword is displayed. Press and
4
hold the smart button
VOICE
keyword. Release the
when the status LED
Press the + button to skip training the
current item and continue to the next.
The Digital Pocket Memo will prompt you
5
to repeat the word. Press and hold the
smart button
VOICE
again. Release the
the status LED
5
was successful) or red (training was not
successful). If the training was successful,
the Digital Pocket Memo will automatically
advance to the next keyword. Repeat from
step until you have trained all keywords.
4
Delete dictation A USB chick charge
Insert mode Delete dictations
Keywords Format memory
Setup Voice cmd traing
Language
BACK ENTER BACK
D Note
If you have configured Voice Command to use
alphanumeric characters, the training procedure
starts with with numbers (0-9), followed by
letters (A-Z), then special characters. For
recognition of letters, say the word for each
letter, such as "alpha" for A, "bravo" for B and
so on.
and say the
4
smart button
VOICE
glows in green.
5
and say the keyword
4
smart button when
VOICE
glows in green (training
B C
ENTER
5
4
3
1
2
23