Battipav Prime 500 Mode D'emploi page 30

GB
IN THE EVENT OF REVERSE MOTOR ROTATION, INVERT THE TWO PHASE PINS INSIDE THE POWER PLUG, AS
INDICATED BELOW
33
• with a screwdriver with a slotted impression, press in the appropriate seat and turn the two phase pins;
• check the correct direction of rotation.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment, disconnect the machine from the supply mains.
Unscrew the knobs and the locking nut located on the disc cover and remove it.
14
Remove the blade fixing nut using the 30 mm spanner and the 5 mm Allen wrench.
THE BLADE FIXING NUT HAS A LEFT-HAND THREAD.
• Install the new blade, checking for correct direction of rotation as clearly indicated on the tool.
• Tighten the blade and put the blade cover guard back in position.
IN ADDITION TO THE KNOBS ALWAYS REASSEMBLE THE LOCKING NUT ON THE DISC COVER.
FOR THE BLADE DISASSEMBLY OPERATIONS, PROCEED AS INDICATED BELOW.
Wearing gloves to protect your hands, hold the diamond blade firmly and use the other hand to unscrew the fixing nut with a 30 mm spanner.
CONTROL DEVICES
15
The PRIME machine is equipped with a control board made up of:
1) START BUTTON: (BLACK COLOUR)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop. The device has an interlocking system. Before starting the machine, make
sure that the device is in release position. Turn it 90° clockwise to unblock it.
3) DEVICE FOR DISCONNECTION FROM THE MAINS (Plug)
Machine power supply point. Use an extension with a 5-pole socket. During the maintenance phases, take out the plug from
the device in order to disconnect the machine from the mains.
4) LASER MARKER (Optional on PRIME 500 - 650 - 700)
It projects the cutting line on the table. It is enabled when the machine is connected to the mains.
CUTTING ON THE TABLE
16
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT AT LEAST 150 cm
ARE LEFT FREE AROUND THE MACHINE. IN ORDER TO WORK IN SAFETY CONDITIONS, DO NOT LET OTHER
PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING OPERATIONS.
17
• Arrange the piece to be cut on the working table at the desired measurement;
BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE MATERIAL IS PROPERLY LEANED
AGAINST THE TILE STOPPER.
17
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount by means of the
water on-off valve located on the blade guard, and cut.
CUTTING UP TO LENGTH OF:
• 1375 mm PRIME 500
• 1300 mm PRIME 500S
• 1100 mm PRIME 650
• 820 mm PRIME 650S
• 970 mm PRIME 700
• 795 mm PRIME 700S
By adjusting the cut start and end carriage stoppers, the entire stroke available for the cutting head carriage can be used and
longer cuts can be obtained.
30
Battipav srl