Kichler Sutter Place Select Manuel D'instructions page 8

STANDARD CEILING INSTALLATION
Step 3. Carefully feed the electrical lead wires from the fan up through the downrod.
Thread the downrod into the coupling until the Hitch pin holes are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 7)
Step 4. Slip the coupling cover, canopy cover, decorative mounting screw cover and canopy
onto the downrod.
Thread the hanger ball onto the downrod, insert the cross pin through the downrod and
tighten. Now tighten the set screw. (Fig. 7)
Step 5. Lift the motor assembly into position and place the hanger ball into the ceiling
mounting bracket.
Rotate the entire assembly until the "Check Tab" has dropped into the "Registration Slot"
and seats firmly. (Fig. 8)
The entire motor assembly should not rotate (left or right) when seated properly.
WARNING: Failure to reattach the cross pin and seat the "Check Tab" can cause the fan to
fall from the ceiling during operation. Take special care to make sure this pin is reattached.
CLOSE-TO-CEILING INSTALLATION
Step 1. Remove three of the six screws and lock washers (every other one) from the collar
on top of the motor assembly. Place the ceiling fan canopy and the rubber gasket over the
collar and align the mounting holes with the holes in the collar. Attach the canopy with the
rubber gasket and the three screws and lock washers previously removed. (Fig. 9)
WARNING: Failure to completely tighten the three mounting screws in step 9 could result
in the fan possibly falling from the ceiling.
Step 2. Hang the fan on the ceiling mounting bracket by inserting the hook on the inside
edge of the ceiling mounting bracket through one of the screw holes in the ceiling canopy
(Fig. 10). This will allow you to have both hands free to make the wiring connections.
8 | KICHLER.COM
Registration Slot
Fig. 8
Screws and Lock Washers
(3 of 6 places)
Coupling
Fig. 9
Hook
Fig. 10
Check Tab
Rubber Gasket
Canopy
Rubber Gasket