Balluff BOD 37M-LA01-S92 Notice D'utilisation page 7

BOD 37M-LA/LB01-S92
Photoelectric Sensors – Laser Distance Sensor
Construction and function
Dimensions
37
M12x1
Output function
BOD-37M-...LA...:
V
10
0.2
0
MIN
BOD-37M-...LB...:
mA
20.5
20.0
4.0
3.5
0
MIN
Installation and connection
The sensor can be fastened
through two holes in the body (1)
with screws, tightening nuts, and
washers. Only fasten the sensor
to the reference surface marked
with A!
www.balluff.com
60
2.9
47.4
MAX
mm
Distance
MAX
mm
Distance
1
A
Installation and connection (continued)
In case of direct fastening, observe an adjustment angle of
±1.5°. The measurement refers to the front surface of the
laser optics (see figure).
Ref.
1. In a de-energized state, connect the M12 connector to
the sensor.
2. Connect the cable to the supply voltage and I/O as
intended for the respective model.
3. Aim the sensor's laser point at the target and fasten
the sensor in a suitable holder with two screws
(e.g. M4×45, with tightening nuts and washers).
Plug diagram
(Top view of the plug on the BOD)
Pin BOS 37M-LA...
1 +24 V ±20%
2 Q2 (≤100 mA)
3
4 Q1 (≤100 mA)
5 Q = 0...10 V
A
Porting configuration
1
5
4
2
3
The measurement function is available just a few
seconds after the device is switched on. To
achieve full accuracy, a warm-up phase of
approximately 20 minutes must be observed.
BOS 37M-LB...
0 V
Q = 4...20 mA
A
+U
B
Q
A
Q1
Q2
0V
english 2