Adjusting The Height Of The Straps - Foppapedretti MYDRIVE Instructions De Montage

2.6 ADJUSTING THE HEIGHT OF THE STRAPS

Adjusting the position of the straps (chest belts), according to the height of the
child's shoulders, is a necessary step in order to adapt the car seat to the growth
of the child. Make sure that the height of the straps is adapted to the height of
the child before installing the car seat in the vehicle.
In the backrest of the car seat there are pairs of slots, at different heights, intended
for this purpose. The straps must be adjusted in the slots close to the child's
shoulders. If the height of the car seat straps is not in line with the height of the
child, follow the steps below:
Loosen the chest belts (see point
Step 1.
2.4) and turn the car seat backwards.
Unclip the harness straps on the back of
the backrest, taking the chest protector
straps off the hook (D) and removing
the two straps from the belt tension
bracket fig.1, fig.2, fig.3.
D
Insert the chest belt and chest protector strap into the
Step 3.
slot on the backrest at the desired height, inserting the belts
into the headrest reducer slot first, then into the lining slot and
the corresponding slot in the backrest shell. Make sure that
the chest belt is inserted inside the chest protector (A) and
that the chest protector strap (B) is underneath the chest belt
(C). Repeat the same steps for the second chest belt.
• ENGLISH •
USING THE CAR SEAT
Adjust one strap at a time, pulling the belt
Step 2.
and the chest protector straps inwards, preventing
them from getting twisted together. Repeat the
same steps for the second strap.
26
C
B
A