Mounting The Range Hood - Forno FRHUC5227-30 Manuel D'instructions

MOUNTING THE RANGE HOOD

Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all exterior
surfaces of the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
Hood Preparation
1.
Remove the filters
2.
Remove either the top or back wiring knock-out and install and approved electrical cable clamp
3.
Remove the rear or top duct knock-out
4.
Install the duct connector/damper
5.
Connect the wiring
6.
Install the under cabinet range hood on kitchen cabinet
7.
Turn power back on
8.
Test the function of the unit, speed and lights
9.
Re-install the filters
INSTALLATION
Note:Measure the distance between stove top and the bottom of range hood,25'' to 30''
is recommended.
1 Mark the screws holes in the bottom of kitchen cabinet as per position of screws holes at the
top of hood
2 Install the screws in the bottom of kitchen cabinet
3 Hook hood onto to screws in the kitchen cabinet
4 Balance the hood body by slightly adjusting the hood mounting
5 screws Tighten all screws until secure