CLAS OC 9119 Mode D'emploi page 9

OC 9119
• Select the bushing suitable for the hole and insert it on the threaded pin with bearing. The opening of the
matrix should face the direction opposite the bearing (Fig.4).
s
• Insert the drive unit with the threaded part into the hole previously drilled in the bumper (Fig.5).
g
4
e,
r
d
r
• Screw the punch on the drive unit's thread (Figures 6+7).
6
• Use a 3/8"
the outside.
A clean hole is created in the bumper without burrs by working from the outside towards the inside (Fig.10).
8
REAR PARKING SENSOR PUNCH TOOL KIT PSA #3 (5 PCS)
ratchet wrench and
The punch is pulled
5
7
then a monkey wrench
into the bushing as
9
to lock the punch
it is screwed (Figures
from
8+9).