Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting the heating element (board)
Disconnect the actuator from the supply vol-
tage.
Take the board out of its packaging and
check for damages.
Do not touch the board itself. Electrostatic
discharge can damage the components.
Screw the three distance bolts (1) into the
assembly bolts.
Screw hand-tight.
Fasten the board (3) to the distance bolts
with the screws (2).
Plug the flat cable into the X1 connector.
Reconnect to supply voltage.
The heating element may not heat at tempe-
ratures over +5 °C.
¥ ‡
!
!
V
§
75
Publicité
Table des Matières
