Subaru SOA801P052 Serie Instructions D'installation page 3

2c
~½"
~½"
VISUALLY ENSURE DOOR EDGE GUARD IS FULLY
ENGAGED, THEN START BACK AT STRIKING POINT #1
CONTINUE WITH FIRM TAPPING MOVING UPWARD BETWEEN TAPPING DOWNWARD ENTIRE LENGTH OF DOOR EDGE
STRIKE POINTS #1 & 4 AT ½ INCH INTERVALS. GUARD.
2d
~1"
=
REPEAT ALL
THUD
DOORS
THUD
2c
ONCE FULLY ENGAGED, PROGRESSIVELY TAP UP ENTIRE LENGTH OF DOOR EDGE
GUARD. IF FULLY SEATED, A SOLID "THUD" SHOULD BE HEARD.
IF NOT HEARD, REPEAT STEP 2c.
Door Edge Guard Removal
THE DOOR EDGE GUARDS ARE MEANT FOR PERMANENT INSTALLATION AND ARE NOT TO BE REMOVED.
IF A DOOR EDGE GUARD IS REMOVED FOR ANY REASON, IT CANNOT BE REINSTALLED.
A NEW DOOR EDGE GUARD KIT MUST BE USED.
~½"
~½"
STARTING FROM EITHER THE TOP OR BOTTOM OF DOOR EDGE GUARD, LIGHTLY TAP NYLON REMOVAL TOOL ALONG GUARD EDGE
IN ½" INTERVALS MOVING DOWN OR UP UNTIL ~2" OF DOOR EDGE GUARD IS DISENGAGED. REPEAT THIS PROCESS AT OTHER END.
ONCE ~2" OF BOTH TOP AND BOTTOM OF DOOR EDGE GUARD IS DISENGAGED, CONTINUE UP OR DOWN ENTIRE DOOR EDGE GUARD
LENGTH UNTIL REMOVAL IS COMPLETE.
ISSUE:
PART NUMBER: DATE: PAGE
SUBARU OF AMERICA
REV. – B
09-14-21
SOA801P052xx 3/7