Heating Operation - Hitachi RAK-18PPA Mode D'emploi

HEATING OPERATION

Use the device for heating when the outdoor temperature is under 21°C.
●
When it is too warm (over 21°C), the heating function may not work in order to protect the device.
In order to maintain reliability of the device, please use this device when outdoor temperature is above -15°C.
●
■ Defrosting
Defrosting will be performed about once an hour when frost forms on the heat exchange of the outdoor unit,
for 5~10 minutes each time.
During defrosting operation, the operation lamp blinks in a cycle of 3 seconds on and 0.5 second off.
The maximum time for defrosting is 20 minutes.
However, if the indoor unit is connected to multi type outdoor unit, the maximum time for defrosting is 15 minutes.
(If the piping length used is longer than usual, frost is likely to form.)
Press the MODE selector button so that the display indicates
1
(HEAT).
Set the desired FAN SPEED with the
(the display indicates the setting).
2 (AUTO)
Set the desired room temperature with the TEMPERATURE buttons
(the display indicates the setting).
3
The temperature setting and the actual room temperature may
vary depending on conditions.
START
Press the (START/STOP) button. Heating operation starts with
a beep. Press the button again to stop operation.
STOP
■ As the settings are stored in the memory of the remote controller, you only
■
have to press the
■ During AUTO fan, the fan speed automatically changes as below:
When the difference between room temperature and setting temperature
●
is large, fan starts to run at HI speed.
After room temperature reaches the preset temperature, fan speed
●
will be changed to lower speed to obtain optimum room temperature
condition for natural healthy heating.
– 11 –
– 11 –
(FAN SPEED) button
(HIGH)
(SILENT) (LOW)
(START/STOP) button next time.
(MED)