switel BSW 200 Manuel De L'utilisateur page 6

4. Set up an Internet connection
The camera will scan for available Wi-Fi networks (SSID). Select the
name of the Wi-Fi network (SSID) that you wish to connect with the
camera and enter the password of your Wi-Fi router if necessary.
First-time setup is now complete.
Note 1: Once you complete Internet setup, the LED on the camera
will turn green after about 1 minute.
2: Wi-Fi SSID is the wireless network name.
3: If the camera cannot find the Wi-Fi network you wish to
connect to, please make sure the camera and the Wi-Fi
router are within range of each other.
4: If you type in the wrong SSID password the camera will
beep three times and then reset to factory default
automatically. Please close the App and follow step 3.3 in
the user manual to set up the camera again.
5: If you have completed Internet set up but the Power/Status
LED is still orange, please check the Wi-Fi router is OK and
make sure the camera and Wi-Fi router are within range of
each other.
6: Make sure your mobile phone is connected to the Wi-Fi
AP/Router you assigned after set up
5