Subaru H011SAJ400 Instructions D'installation page 6

6
MAIN HARNESS CONNECTIONS
6-PIN IGNITION SWITCH CONNECTIONS
1. Locate the 6-pin ignition switch connector on the right side of the steering
column and unplug. (FIGURE R)
2. Plug the previously unplugged vehicle's female ignition switch connector into
the remote start ignition harness 6-pin male connector. (FIGURE S)
3. Plug the remote start ignition harness 6-pin female connector into the vehicle's
ignition switch. (FIGURE S)
4-PIN & 2-PIN PRE-FIT CONNECTIONS ABOVE & BEHIND FUSE PANEL
1. Locate the vehicle's 4-pin and 2-pin pre-fit connections located behind the
fuse panel to the left of the steering column. These connectors are secured
to the vehicle wiring using breakaway tape. (FIGURE T)
2. When the 2-pin pre-fit connector is located, unplug and discard the mating
wire jumper. (This is used for the power window interrupt circuit)
3. Plug the remote start pre-fit jumper harness 4-pin and 2-pin male connectors
into the corresponding 4-pin and 2-pin vehicle female connectors.
(FIGURE U)
PART NUMBER
ISSUE
H011SAJ400 00
All manuals and user guides at all-guides.com
DATE
21 Apr 2013
SUBARU OF AMERICA
FIGURE R
FIGURE S
Pre-fit
Connectors
FIGURE T
FIGURE U
6 OF 11