Table des Matières
Publicité
Set the range switch to "°C" position.
1.
Connect the negative " - " (or black) plug of the Κ type
2.
thermocouple to the "COM" jack, and the positive " + "
(or red ) plug to the "mA°C" jack.
Connect the other end of the thermocouple to the object to be
3.
measured.
Wait a while, and then read the reading on the display.
4.
Measuring Relative Humidity
You can use the meter to measure relative humidity with the built-in
humidity sensor. The sensor is located near the mark "%RH" on the
top of the meter (Figure 2).
1.
Set the range switch to "%RH" position.
2.
Place the meter in the environment where the measurement of
relative humidity is needed.
3.
Wait until the reading is stable.
Read the reading on the display.
NOTE:
When you place the meter in a new environment with a different
humidity, you should wait until the reading is stable.
All manuals and user guides at all-guides.com
28
Publicité
Table des Matières
