Drill A Hole For The Reverse Osmosis Faucet - Watts Premier 500320 UV-3 Manuel D'installation, D'utilisation Et D'entretien

Drill a Hole for the Reverse Osmosis Faucet

Marble Counter-top
We recommend contacting a qualified contractor for drilling a hole in a marble counter-top.
Counter Top / Porcelain & Stainless Steel Sink
Most sinks are pre drilled with 1 ¼" diameter hole that you can use for your RO faucet.
Note:
(If you are already using it for a sprayer or soap dispenser, see step 1)
Porcelain sinks are extremely hard and can crack or chip easily.
Use extreme caution when drilling. Watts accepts no responsibility for
damage resulting from the installation of faucet. Diamond tip bit recommended.
Step 1 Determine desired location for the RO faucet on your sink and place
a piece of masking tape over where the hole is to be drilled. Mark the
center of the hole on the tape.
Step 2 Using a variable speed drill set on the slowest speed, drill a 1/8" pilot
hole through both porcelain and metal casing of sink at the marked
center of the desired location. Use lubricating oil or liquid soap to keep
the drill bit cool (If drill bit gets hot it may cause the porcelain to crack
or chip).
Step 3 Using a 1/2" diamond tip hole saw, proceed to drill the large hole. Keep
drill speed on the slowest speed and use lubricating oil or liquid soap
to keep the hole saw cool during cutting.
After drilling, remove all sharp edges and make sure the surroundings
Step 4
of the sink are cooled before mounting the faucet.
Mount the Faucet & Connect Blue Tube to Faucet
Refer to installation instructions found on faucet box.
Mount the faucet and connect 1/4" blue tube found in the shipping box to the faucet.
All manuals and user guides at all-guides.com
5