CLAS OC 9132 Mode D'emploi page 8

REAR PARKING SENSOR PUNCH TOOL KIT BSEAT/VW (5
OC 9132
PCS)
DESCRIPTION
The tool set described in this manual is used to make clean holes in plastic bumpers without burrs. This is
necessary when the replacement bumper supplied by the manufacturer does not have the holes for mounting
the parking sensors.
According to some manufacturers' repair instructions, holes should be drilled only after painting to guarantee,
once repaired, an appearance as close to the original as possible.
Furthermore, the centering pins contained in the tool set ensure the correct fixing and alignment of the sensor
supports during fastening (welding/gluing).
This tool set features a choice of the most used measures, also including odd intermediate measures, as prescribed
by different manufacturers. It is suitable for standard parking sensors (PDC=Park-Distance-Control) and for
parking assistance sensors (PLA=Parking Assistant).
The OEM numbers shown are used only for assigning technical data and fields of use!
INSTRUCTIONS
Always adhere to the vehicle manufacturer's recommendations and repair instructions!
• As a rule, the position of the sensors is marked by the manufacturer with markings on the inside of the
bumpers (Figures 1+2). The supplied assembly tool set may contain a template suitable for the vehicle and/or
the bumper.
1
• Use a Ø10 mm
for each marking
Place the drill exactly in the middle of the marking
and drill from the inside to the outside (Fig.3).
drill to drill a hole
on the bumper.
2
3