Paddle Preparation - SPORTSTECH WPB320 Manuel

The following describes how to inflate with the supplied hand pump.
4. Set up the pump. Connect the hose to the pump connection.
5. Connect the other end of the hose to the valve on the SUP board.
6. Fix the pump with your feet. Inflate to a positive pressure of 12 to 15 psi (0.8 to 1.0 bar).
7. Unscrew hose from valve. Screw on the valve protection cap.
• The valve is only tight if the protective cap is screwed on tightly.
Mount Middle Fin
1. Push the fin into the holder.

7. PADDLE PREPARATION

A
B
2. Lock the fin in place with the slide-in clip on the side.
3. Check that the insertion clip is secure.
1. Insert lower end of center
tube ('B') into paddle tube
('C'). Make sure that the sa-
fety spring ball ('i') engages in
the safety hole ('ii').
2. Insert the handle tube ('A')
into the center tube connector
('B'). Note the minimum inser-
C
tion depth.
3. The overall length of the
paddle can be varied between
1.65 m and 2.10 m (5.4 to
6.9 ft). The deeper the grip
tube is inserted, the shorter
the paddle.
4. Secure connection with safety
lever ('iii').
23
B
i
C
A
iii
B
EN
ii