Parameter Setting - Piscine Center PLATINIUM 095 Manuel D'utilisation

6.2.6 Parameter checking
Select and press
Code
d0 IPM mould temperature
d1 Inlet water temp.
d2 Outlet water temp.
d3 Ambient temp.
d4 Frequency limitation code
d5 Piping temp.
d6 Gas exhaust temperature
d7 Step of EEV
d8 Compressor running frequency
d9 Compressor current
d10 Current fan speed
d11 Error code for last time
Remark:
d4: Frequency limitation code,
0: No frequency limit;
2: Overheating or overcooling frequency limit;
8: Drive voltage frequency limit;
6.2.7

Parameter setting

Select and press
Note: Long press
Code Name
P0 Mandatory defrosting
P3 Water pump
P7 Water temp. calibration
to enter, press
Condition
to enter, press
for 15s to set P14, P18.
Scope
0-1
0-1
-9～9
and to check d0-d11 value.
Scope
0-120℃
-9℃ ～99℃
-9℃ ～99℃
-30℃ ～70℃
0,1,2,4,8,16
-30℃ ～70℃
0℃ ～C5℃ (125℃ )
0～99
0～99Hz
0～30A
0-1200 (rpm)
All error code
1: Coil pipe temperature limit;
4: Drive Current frequency limit;
16:Drive high temperature frequency limit
and to choose P0-P18 value and press
Default
0: Default normal operation
0
1: mandatory defrosting.
1:Always running;
0
0:Depends on the running of compressor
0 Default setting: 0
59
Remark
Real testing value
Real testing value
Real testing value
flash if Real value<-9
Real testing value
flash if Real value<-9
Real testing value
N*5
Real testing value
Real testing value
Real testing value
to set.
Remark