Configuration - auna Roadie Smart Mode D'emploi

CONFIGURATION

Here you will find the complete settings / options available to configure
your own tuner. On the main menu, navigate to the configuration setting.
Press enter button and you will see a list of available options .
Network
Wi-Fi Network
Add / Remove AP
Add AP - It will scan a list of wireless networks in the area.
Add AP (WPS button) - If WPS button is available on your router, you
can choose this option to quickly connect to your Wi-Fi network without
entering the password. Select this option on the boombox and press
the enter button, it will show "Awaiting router info" on the display. In the
meantime, press the WPS button on your router within one minute. It will
time out if no action is taken. It is strongly recommended to place your
radio within 2 metres to the router to setup.
Notes:
• In case the connection through WPS is not successful, repeat the steps
above and try again.
• Remove AP - If you have already added a wireless network and want to
remove it, choose this option.
• Always place the radio within 2 metres of the Wi-Fi router forest up.
AP: [ ]
If you have added more than one wireless network on the radio and want to
switch to another one, select this option to change.
Signal
This is to show the strength of the Wi-Fi signal of the Wi-Fi router as
received by the radio. Usually signal levels lower than -70 dBm are at a
weaker level. If it affects the reception of your radio, you may need to
optimise the router location or check any problem of the router itself.
IP
The IP is set to Dynamic by default. Select to change Fixed IP according to
your network condition.
DNS
The DNS is set to Dynamic by default. Select to change <Fixed>DNS
according to your network condition.
EN
49