Topdon Tornado4000 Mode D'emploi page 7

positive first for positive ground systems).
*Note:
• DO NOT connect the AC power plug until all other connections are made.
• DO NOT make any connections to the carburetor, fuel lines, or thin, sheet metal parts.
• DO NOT face the battery when contacting the AC power plug into the electrical outlet.
4. Begin Charging
1) Verify the voltage and chemistry of the battery.
2) Confirm if the proper connection has been made between the battery clamps (eyelet
terminal connectors) with battery terminals, and the AC power plug is plugged into the
electrical outlet.
3) The charger will begin in Standby mode, with no power provided, indicated by a Blue LED.
4) Press the Mode button twice to toggle to the appropriate charge mode for the voltage and
chemistry of the battery. The mode LED will illuminate the selected charge mode.
5) Press it once to start charging after the selection. The charge LEDs will illuminate when
the charging process is started, depending on the health of the battery.
6) The charger can now remain connected to the battery for the needed charge.
10
5. Understanding Charge LEDs
LED
• When the battery is <25% charged, the 25% White LED will
slowly flash.
25% White LED
• When the battery is 25% charged, the 25% White LED will
become solid.
• When the battery is >25%, and <50% charged, the 50% White
LED will slowly flash.
50% White LED
• When the battery is 50% charged, the 50% White LED will
become solid too.
• When the battery is >50%, and <75% charged, the 75% White
LED will slowly flash.
75% White LED
• When the battery is 75% charged, the 75% White LED will
become solid too.
• When the battery is >75%, and <100% charged, the 100%
White LED will slowly flash.
100% White LED
• When the battery is 100% fully charged, the 100% White LED
will become solid too.
Explanation
11