Testing Of The Appliance; Adjustments - Angelo Po 1G1BR1E Manuel D'utilisation Et D'installation

TESTING OF THE APPLIANCE

Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
RECOMMENDATIONS FOR ADJUSTMENTS
Important
Before making any type of adjustment, acti-
vate all the safety devices provided and de-
cide whether staff at work and those in the
vicinity should be informed.
ADJUSTING THE LID COUNTER-BALANCING
To carry out this operation, proceed as follows.
1 - Fit the spanner (A) onto the hexagon (B).
2 - Keep a firm grip on the spanner (A) and undo
the locking screws (C).
3 - Turn the spanner (A) clockwise to load the
spring or anti-clockwise to release it.
4 - Once the correct balance is obtained, screw in
the screws (C) without tightening them fully.
5 - Use the spanner (A) to turn the shaft until it is
located in one of the seats provided.
6 - Fully tighten the screws (C).
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.

ADJUSTMENTS

In particular, turn off the electricity sup-
ply using the circuit-breaker and prevent
access to all devices which might people's
health and safety at risk if activated.
- 15 -
1 - check that the mains voltage is the same as that
of the appliance;
2 - operate the appliance's circuit-breaker to check
the electrical connection;
3 - check that the safety device is operating cor-
rectly.
C
A
B
8
IT
GB
DE
FR
ES
IDM-39604009200.tif
English