Important Notice - HeraCeram Zirkonia 750 Mode D'emploi

Firing procedure
IMPORTANT NOTICE: The firing temperatures given are intended as guidelines. Deviations are pos-
sible due to varying furnace power and types and may need to be adapted.
General firing table
zirconium dioxide
Start temperature
Drying
Pre-heating
Temperature increase
Final temperature
Holding time
Vacuum start
Vacuum stop
* Start temperature 600°C for stain shade and glaze pastes!
General firing table
lithium di-silicate
Start temperature
Drying
Pre-heating
Temperature increase
Final temperature
Holding time
Vacuum start
Vacuum stop
* Start temperature 600°C for stain shade and glaze pastes!
Safety instructions
This product or one of its components may, in particular cases, cause hypersensitive reactions. If any
reaction is suspected, information about the ingredients can be obtained from the manufacturer. Never
swallow or ingest this product! Avoid contact with eyes. In case of contact with eyes, rinse immediately
and thoroughly with plenty of cool water and seek medical advice. The use of this product is contrain-
dicated in cases of known or suspected allergies to components of the ceramic. In the case of a sus-
pected allergy, we recommend taking an allergy test prior to use. The data given are furnished to the
best of our knowledge and are based on in-house test results. To be used only by dental technicians
for its intended purpose.
Please observe the information in the corresponding safety data sheet.
Please quote the batch number in all correspondence about the product.
Batch number : See note on packaging.
1502_3711_GBA_HeraCeram_Zirkonia_750.indd 5 1502_3711_GBA_HeraCeram_Zirkonia_750.indd 5
Adhesive 750 Primary dentine
°C 500 500
min 5 5
min 1 1
°C/min 75 60
°C 800 750
min 2 1
°C 500 500
°C 800 750
Adhesive 750 Primary dentine
°C 400 400
min 5 5
min 1 1
°C/min 50 50
°C 750 750
min 1 1
°C 400 400
°C 750 750
Secondary dentine Glaze
500 500*
5 4
1 1
60 60
745 725
1 1
500 –
745 –
Secondary dentine Glaze
400 400*
5 4
1 1
50 60
745 725
1 1
400 –
745 –
Correction material
500
4
1
60
720
1
500
720
Correction material
400
4
1
50
715
1
400
715
Dated: 2015-05
5
20.05.15 11:59 20.05.15 11:59