Uline H-3506 Guide Rapide page 2

INSTALLING REAR HINGE BRACKETS
1. Line up one right bracket with the rear right side of
hopper lip. (See Figure 1)
2. Mark centers of the two holes in the bottom of the
bracket. Remove bracket and drill two 3/8" holes into
the hopper lip.
3. Place bracket back on hopper and line up holes.
4. Secure bracket to hopper lip using 2 bolts and 2
lock nuts. (See Figure 2)
5. Repeat steps 1-4 with one left bracket on the rear
left side of the hopper.
INSTALLING FRONT LOCK BAR BRACKETS
NOTE: Front lock bar brackets only need to be
installed if you are going to be using the lock
bar to lock the lid.
6. Measure 6" back from the front right side of the
hopper. (See Figure 3)
6"
7. Repeat steps 2-4 to install one right bracket.
PAGE 2 OF 9
ASSEMBLY
8. Repeat steps 6-7 with one left bracket on the front
Figure 1
INSTALLING THE LID
9. The shape of the lid should allow it to fit inside all
4 brackets, but it might be necessary to cut small
(See Figure 5)
Figure 2
10. Insert hinge bar through all lid hinge sockets.
(See Figure 6)
Figure 3
left side of the hopper. (See Figure 4)
Front lock bar brackets (optional)
Rear hinge brackets
notches out of the lid for it to fit properly.
NOTE: In hoppers with two-piece design,
there will be a right and left lid.
Figure 4
Figure 5
Figure 6
0621 IH-3506