Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
H-16
BETTER PACK
CADILLAC 755
TAPE DISPENSER
UNPACKING NOTES
When unpacking your new electric machine, check the
following before discarding packaging material:
1. There should be two brushes in the water tank.
2. The upper tape plate is held in position by
packaging materials but may have been dislodged
in shipping. Remove all holding material before
using machine.
SETTING UP YOUR MACHINE
1.
If the upper plate has been dislodged in shipping,
replace as follows: With the center slot toward the
front of the machine, slide under feed wheel shaft
from the rear until the cut-out portions on sides are
over the retaining "buttons." Drop plate and slide
forward so that end of plate is under the rod just to
the rear of the shear and the back end is under the
"buttons."
2. Remove tank and brushes. Wash brushes thoroughly
in warm water and soap or mild detergent. Replace
brushes in water tank. Note the two brushes are
beveled. Replace them in tank, being sure each
brush is positioned with the high side toward the
front of the tank. Replace tank and brushes in the
machine.
3. Fill bottle with water and place in the bottle holder
so the spout of the bottle is in the tank. Set correct
water level. (See adjustments, water level.)
PAGE 1 OF 9
All manuals and user guides at all-guides.com
1-800-295-5510
uline.com
INSTRUCTIONS
4. Adjust roll guides inside rear of machine to proper
width for tape. (See roll guide adjustment.)
5. Loading tape: Take the roll and unwind about 18".
Place the roll in the basket so that the strip unwinds
off the rear of the roll as the leading end is brought
up toward the front of the machine with gummed
side down. Thread tape over the roller at the upper
rear and slide leading edge forward under upper
tape plate and feed wheel.
6. Set pressure plate weight and top heater
temperature. (See adjustments, moistening and top
heater settings.)
7.
Electrical Connection
a. Plug Machine into wall outlet.
WARNING! For your safety all the metal parts of
this machine are electrically grounded through
a 3-wire power supply cord and a 3-prong
grounding type plug, which must be plugged
into a 3-wire grounded type receptacle. If
you are not sure the electrical system in your
building is properly grounded, call a licensed
electrician.
b. When all connections have been made, turn on
the power switch at the right front of machine.
Pilot light should light and indicates the machine
is ready for operation.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
0521 IH-16
Publicité
Manuels Connexes pour Uline CADILLAC 755
Sommaire des Matières pour Uline CADILLAC 755
- Page 1 All manuals and user guides at all-guides.com Pour le français, consulter les pages 7-9. H-16 1-800-295-5510 uline.com BETTER PACK CADILLAC 755 TAPE DISPENSER INSTRUCTIONS UNPACKING NOTES 4. Adjust roll guides inside rear of machine to proper width for tape. (See roll guide adjustment.) When unpacking your new electric machine, check the 5.
- Page 2 All manuals and user guides at all-guides.com INSTRUCTIONS CONTINUED ELECTRIC ADJUSTMENTS • For example, certain gummed paper tapes have glue, which normally requires somewhat less water ROLL GUIDE ADJUSTMENT for best moistening results. With such tapes very little weight is required and all weights at front of pressure •...
- Page 3 WARNING! Do not oil feed wheel shaft. Oil • Remove accumulations of old dried glue from the can creep in through the bearings and affect under side where it touches the moistening brushes. internal parts. 1-800-295-5510 uline.com PAGE 3 OF 9 0521 IH-16...
- Page 4 All manuals and user guides at all-guides.com H-16 800-295-5510 uline.mx BETTER PACK CADILLAC 755 DESPACHADOR ELECTRÓNICO DE CINTA ADHESIVA INSTRUCCIONES INDICACIONES PARA DESEMPAQUETAR 4. Guía de ajuste del rollo dentro de la parte posterior de la máquina para el ancho adecuado de la Al desempaquetar su nueva máquina eléctrica,...
- Page 5 All manuals and user guides at all-guides.com CONTINUACIÓN DE INSTRUCCIONES AJUSTES ELÉCTRICOS • Por ejemplo, algunas cintas adhesivas de papel engomado tienen pegamento, que a menudo GUÍA DE AJUSTE DEL ROLLO requiere algo menos de agua para conseguir los mejores resultados de humectación. Con dichas •...
- Page 6 El aceite puede • Quite los restos de pegamento seco de la parte penetrar a través de los casquillos y afectar a inferior donde toca los cepillos de humectación. las partes internas. 800-295-5510 uline.mx PAGE 6 OF 9 0521 IH-16...
- Page 7 All manuals and user guides at all-guides.com H-16 1-800-295-5510 uline.ca BETTER PACK CADILLAC 755 - DÉVIDOIR DE RUBAN ADHÉSIF INSTRUCTIONS REMARQUES SUR LE DÉBALLAGE 4. Ajustez les guides du rouleau à l'intérieur de l'arrière de l'appareil à la largeur du ruban. (Voir réglage du Lorsque vous déballez votre nouvel appareil électrique,...
- Page 8 All manuals and user guides at all-guides.com INSTRUCTIONS SUITE RÉGLAGES ÉLECTRIQUES • Par exemple, certains rubans en papier gommé ont de la colle, ce qui nécessite normalement AJUSTEMENT DES GUIDE DU ROULEAU un peu moins d'eau pour assurer une meilleure humidification.
- Page 9 • Retirez la vieille colle séchée accumulée sur de la roue d'alimentation. L'huile peut se glisser la face inférieure où se touchent les brosses à travers les roulements et endommager les d'humidification. pièces internes. 1-800-295-5510 uline.ca PAGE 9 OF 9 0521 IH-16...