CYBEX RUBY Manuel D'instructions page 9

Instructions for use
III.
IMPORTANT:
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE
REFERENCE. YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
Please fold out the pages with illustrations which can be found in the back of this
manual and then refer to the instructions.
1. OPENING THE STROLLER
1. Release the folding lock lever.
2. Open the stroller.
3. Push the pedal button down until the locking system is engaged.
WARNING: ENSURE THAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE.
2. ASSEMBLING THE FRONT WHEELS
1. Snap in the front wheels until the snap finger is engaged.
3. ASSEMBLING THE BASKET
1. Slide the two front loops of the basket over the seat tubes.
2. Hook in the remaining two loops in the basket´s corners into the two C-shaped rings
on the rear tubes.
Reverse this procedure to take the basket off.
4. USING THE BRAKES
1. Use your foot to push the brake lever down on one of the back wheels to engage the
brakes. The brakes of the back wheels are linked to each other, so that both brakes are
operated simultaneously.
2. Lift the brake lever again to release the brake.
WARNING: ENSURE THAT THE PUSHCHAIR IS ALWAYS IN THE BRAKE POSITION WHEN
YOU PUT YOUR CHILD INTO THE SEAT.
5. AUTOMATIC FRONT WHEEL SWIVEL LOCKS
1. Lift the Front Swivel Lock Lever until it "clicks" in, in any wheel position. The Swivel lock
will be engaged automatically when it reaches in the right position.
2. Push the Front Swivel Lock Lever down again to release the Swivel Lock.
3 UK
6. USING THE HARNESS SYSTEM
1. To fasten the harness system – insert left and right side fasteners into the central
harness buckle.
2. Adjust the shoulder straps with the corresponding sliders.
3. To release fasteners squeeze the grooves on left and right side of the central harness
buckle to release the belts.
WARNING: ALWAYS USE THE CROTCH STRAP IN COMBINATION WITH THE WAIST BELT.
7. ATTACHING THE HOOD
1. Click the hood's hooks into the supports on the front tubes on left and right side and
extend the hood.
2. Close the canopy stretchers on left and right side to stretch the hood.
3. To fold back the hood, lift the back part of the stretcher.
4. To release the hood press the hooks and remove.
8. RECLINING THE SEAT
The CYBEX RUBY has two different recline positions.
1. To recline the backrest pull out the hooks on left and right side of the front tubes.
2. Then hook them into the corresponding supports on the rear tube.
Ensure that the hooks are fastened properly before you put your child back into the seat.
WARNING: NEVER RECLINE THE SEAT WHILE YOUR CHILD IS IN IT.
9. FOLDING THE STROLLER
Remove all contents from the basket.
Release canopy stretchers if the hood is fitted. Ensure the hood is folded back.
1. Push the primary lock lever underneath the pedal button.
2. Lift the pushed primary lock lever to release the stretching system.
3. Push down the secondary lock lever (extended bar on right side of the locking system)
4. Grip handles and push forward on stroller to fold it.
Press folded stroller until the storage clip is engaged.
It is recommended to fasten the harness before folding the stroller.
10. CARRYING THE STROLLER
1.Pull the flexible carry handle on left rear tube and lift the stroller.
3
UK