Cleaning The Nozzle And Spinbrush - Oreck SURFACESCRUB FK40100 Serie Manuel Du Propriétaire

CLEANING THE NOZZLE AND SPINBRUSH

Important: The tanks should be emptied and cleaned after each use and before storage.
Nozzle can be removed for easy cleaning. Slide
the two nozzle release latches outwards.
! !
CAUTION!
TO REDUCE THE RISK OF INJURY FROM MOVING
PARTS—UNPLUG BEFORE SERVICING.
All manuals and user guides at all-guides.com
Remove nozzle by tilting downward and then
pulling straight out and rinse under running
water to clean.
L U B R I C AT I O N : THE MOTOR IS EQUIPPED WITH
BEARINGS WHICH CONTAIN SUFFICIENT LUBRICATION FOR
THEIR LIFETIME. THE ADDITION OF LUBRICANT COULD
CAUSE DAMAGE. DO NOT ADD LUBRICANT TO MOTOR.
Pull spinbrush bar out. The brushes can
be rinsed under water to remove debris
(Max 100°F). To replace the spinbrush,
press firmly and lock into place. Then
replace nozzle and click nozzle latches
back into place
19