Power Switch; Changing The Filter Bag; Assembly Instructions - Oreck XL SIMPLY AMAZING BB870-AW Guide D'utilisation

Blower Port
Blower Port
The blower port is located at the rear
of the machine. Installation of tools is
the same as described for suction port.
Cord Dump
Twist cord dump to easily release
stored cord.
Plug cord into electrical outlet.

Power Switch

Push power switch to "ON" (I) position.
Assembly
Attach Caddy and Insert Tools
Locate caddy clip indents at top rear
corners of appliance. Place appliance
on firm, non-slip surface or hold in
your lap. Grasp handle firmly. Place
end of caddy in outside indent then
strongly push and pull other end of
caddy into opposite indent. Be sure
rims on caddy openings face up.
Avoid trapping fingers when caddy
snaps on; painful pinch could result.
E N G L I
If caddy needs to be removed, a large
flat-head screwdriver inserted under
caddy clip at indent can be used to
carefully pry caddy loose.
Pull cord through center opening in
caddy and push until it is seated at
back of slot at rear of center opening
in caddy.
Insert crevice tool, brush and fabric
tool into caddy in spaces provided.
A

CHANGING THE FILTER BAG

A. Use only genuine ORECK XL filter
bags. Stand unit on its back. Holding
strap away from door, twist knob
counterclockwise to release and lift out
front plate. B.
5
S H
Maintenance