Samsung WF448AAW Mode D'emploi page 26

troubleshooting
ERROR IMAGE
Error!
Power Interruption
Error!
Water Supply
Problem
Error!
A button is either stuck
or is being pressed
continuously.
Error!
The motor is not
working properly.
Error!
Temperature Sensor
Problem
Error!
High/Low Voltage
Delected
Error!
SilverCare
TM
Error!
Excessive Suds
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
26_ Troubleshooting
WF448AAW-02535B_EN.indd 26
MEANING
Problem with control.
A fault is detected in the water level
sensor.
Jammed Key.
• Motor speed sensor problem.
• High current detected.
• Motor not running properly.
Temperature sensor problem.
High/Low voltage detected.
SilverCare™ control problem
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
SOLUTION
Call for service.
Call for service
Call for service
Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
To prevent it, cut down on detergents.
2008-04-25 ¿ÀÀü 10:30:29