English
Charging
To keep the battery charged, place the handset in the telephone base or telephone charger
when not in use� The battery is fully charged after 10 hours of continuous charging�
If the screen is blank, you need to charge the handset without interruption for at least 30
minutes to give the handset enough charge to use the telephone for a short time�
When the batteries are running low a warning tone is heard and LOW BATTERY and
flashes
on the display�
After you install your telephone or power returns following a power outage, date and time needs
to be set� See "Date / Time" on page 7 for more information�
Range
This cordless telephone operates with the maximum power allowed by the Federal
Communications Commission (FCC)� Even so, this handset and telephone base can
communicate over only a certain distance - which can vary with the locations of the telephone
base and handset, the weather, and the layout of your home or office�
When the handset is out of range, the handset displays OUT OF RANGE OR NO PWR AT BASE�
If there is a call while the handset is out of range, it might not ring, or if it does ring, the call
might not connect well when you press
/ FLASH� Move closer to the telephone base, then
press
/ FLASH to answer the call�
If the handset moves out of range during a telephone conversation, there might be interference�
To improve reception, move closer to the telephone base� Coverage can be improved by turning
the head so that the handset is facing the base unit�
4