Equipment Approval Information - Widex PHONE-DEX Mode D'emploi

FCC, ACTA and IC regulations
This equipment has been tested and found to comply with the requirements for a Class B digital device
under Part 15 of the Federal Communications Commission (FCC) rules� These requirements are intended
to provide reasonable protection against harmful interference in a residential installation� This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications� However, there is no guaran-
tee that interference will not occur in a particular installation� If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna�
•
Increase the separation between the equipment and receiver�
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected�
•
Consult the dealer or an experienced radio/TV technician for help�
Changes or modifications to this equipment not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment� This device complies with Part 15 of the FCC
rules� Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation� Privacy of communications may not
be ensured when using this telephone�
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that
can be safely absorbed by a user or bystander according to the intended usage of the product� This prod-
uct has been tested and found to comply with the FCC criteria� The handset may be safely held against
the ear of the user� The telephone base shall be installed and used such that parts of the user's body other
than the hands are maintained at a distance of approximately 8 inches (20 cm) or more�
This Class B digital apparatus complies with Canadian ICES-003�
FCC Part 68 and ACTA
This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the
Administrative Council for Terminal Attachments (ACTA)� The label on the back or bottom of this equip-
ment contains, among other things, a product identifier in the format US:AAAEQ##TXXXX� This identifier
must be provided to your local telephone company upon request�
The plug and jack used to connect this equipment to premises wiring and the telephone network must
comply with applicable Part 68 rules and technical requirements adopted by ACTA� A compliant telephone
cord and modular plug is provided with this product� It is designed to be connected to a compatible modu-
lar jack that is also compliant� An RJ11 jack should normally be used for connecting to a single line and an
RJ14 jack for two lines� See Installation Instructions in the user's manual�

Equipment Approval Information

English
18