Intercom; Find Handset; Add And Register Additional Handset - Widex PHONE-DEX Mode D'emploi

Your handset and base station is pre-registered� Up to five handsets can be registered to the
base station� Each new handset is assigned in sequential order� The number is shown on the
display� The base unit should be positioned centrally so that the coverage area is roughly equal
for all handsets�
If for some reason, the handset is not registered to the base station (OUT OF RANGE OR NO
PWR AT BASE is displayed even when the handset is near the base station), register your
handset according to the following procedure�

Find handset

Press the find handset icon ( J ) on the telephone base once� The handset rings and the
display shows **PAGING**� To stop:
• Press the find handset icon on the telephone base again�
• Press q / FLASH,
• Place the handset in the telephone base or charger�

Add and register additional handset

1� Place the new handset in the telephone base or charger�
2� On the telephone base: press and hold the find handset icon J for 5-8 seconds�
3� On the handset: remove the handset from the telephone base or charger�
Press MENU / SELECT
is displayed�
When the registration is complete, HANDSET REGISTERED is displayed�
If the handset registration is successful, you will hear a confirmation tone� The handset will
automatically be allocated the next available handset number� If the handset registration is
unsuccessful, the OUT OF RANGE OR NO PWR AT BASE will again be displayed�
Replace handset
If you want to replace a handset or reassign the designated handset number, you must
unregister all handsets and then individually register each handset�
On the telephone base: press and hold the find handset icon J for about 10 seconds, then
press J again�
English

Intercom

or any dialing key (0-9,
â
REGISTRATION OR press
or )�
and REGISTERING��� PLEASE WAIT
13