Power Fist 8154700 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Chapter 2 – Assembly
2.1
Ground installation.
If installing the unit to the floor or other fixed surface, ensure that the unit will have proper
ventilation, and will be protected from exposure to dust, dirt, and water. The distance between the back of
the unit and any wall must be a minimum of 46 cm.
2.2
Checking the package contents.
• After receiving the equipment, check for any signs of damage during transport. Notify the dealer
immediately if the unit is damaged or is missing any parts.
• Remove unit from packaging and remove all packing material. Check for loose pieces in box.
• Check all air vents in the unit case. Remove any packaging material blocking vents.
• Assembly of unit should be done where adequate room is available.
2.3
Installation (refer to fig. 2-1).
Note: 8154700 model does not include kickstand, wheels, axle, handle or brace.
2.3.1 Installing the kickstand (except 8154700).
Position the plastic block into the slot on the front chassis of the unit, and secure using
tapping screws.
Fig. 2-1
Page 5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8154718

Table des Matières