Video Settings - Panasonic TY-SB01QS Mode D'emploi

Video settings

By installing this product in a compatible display and
setting the display's input to [SLOT], video setting can
be made.
Note
●
Some displays are not supported.
The setting can be made on [Signal] for the main unit
menu.
■
[SDI format select]
Select the 12G-SDI/3G-SDI/HD-SDI format.
[Auto]:
Automatically detects the input signal format.
[4:2:2 YC C 10bit], [4:4:4 YC
B R
[4:4:4 RGB 10bit], [4:2:2 YC
[4:4:4 YC C 12bit], [4:4:4 RGB 12bit]:
B R
If the video is not correctly displayed because
the Payload ID is not superimposed or for other
reasons, the above formats can be selected
manually. Note that some input signals may not be
supported.
■
[Signal range]
Switches the dynamic range to match the signals.
[Auto]:
Switches the dynamic range automatically between
[Video(16-235)] and [Full(0-255)] according to the
input signal.
[Video(16-235)]:
If the input signal is the video range.
[Full(0-255)]:
If the input signal is full range.
■
[Dynamic range]
Switches the dynamic range.
[Auto]:
Sets automatically according to the Payload ID
information.
[HDR(PQ)]:
Sets the dynamic range in compatible with HDR
(PQ (Perceptual Quantization)).
[HDR(HLG)]:
Sets the dynamic range in compatible with HDR
(HLG (Hybrid Log Gamma)).
[SDR]:
Sets the dynamic range in compatible with SDR.
■
[Colour gamut]
Switches the colour gamut.
[Auto]:
Sets the colour gamut automatically according to
the ITU-2020 emu. information of Payload ID.
[Native]:
Displays with the colour space unique to this unit.
6
English
C 10bit],
B R
C 12bit],
B R
[ITU-2020 emu.]:
Displays with the colour space close to the ITU-R
BT2020 standard.
■
Input signal display
Display the frequency of the signal currently being
input and the type of signal.
H-freq.
135.00 kHz
V-freq.
60.00
Dot clock freq.
594.00 MHz
Signal format
3840x2160/60p
Status
[Status]:
If the input signal has any of the following errors, a
message is displayed.
[No ID]
Payload ID has not been superimposed.
[ID]
Payload ID does not match the horizontal / vertical
information of SDI signal.
[CRCC]
Displayed when CRCC error occurs due to poor
signal quality, etc. (A high-frequency cable such as
5C- FB may not be used for transmission.)
Note
●
If there is no video signal in the SDI input, a full
blue screen is displayed. If a signal unsupported
by this product is input to the SDI input, a full cyan
screen is displayed.
Hz