1 .5 WARNING SIGN ON THE MACHINE
The warning sign is placed on the switch cabinet of
the machine, see Figure 2.
Danger due to electric current
1 .6 NAMEPLATE
The nameplate is placed on the back of the
machine.
Figure 1
Position of nameplate
2 Technical Description
2 .1 INTENDED PURPOSE
This machine is a hydraulic insertion machine
for flat workpieces and the related self-clinching
fasteners. Only workpieces and self-clinching
fasteners that do not exceed the maximum press-in
force of the machine may be processed with this
machine, see chapter 2.6.
2 .2 USE LIMITATIONS
In each of the following cases a trouble-free and
safe operation is not ensured:
•
The machine is not used according to this
manual.
•
The operators are not trained.
•
The machine is used for any other than the
intended purpose.
2 .3 OPERATING TYPES
There are two different modes
within each operating type:
•
Non-conductive materials
•
Conductive materials
2 .3 .1 Operating type setup
This operating type is used only for setting up the
machine. Within this operating type the press-in
force is adjusted.
2 .3 .2 Operating type operation
This operating type is used to press in the
self-clinching fasteners.
English | 35