Two Point Mode Procedure - CARLO GAVAZZI IO-Link PD30ETP/R Serie Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 89

2.6.2.2. Two point mode procedure

1) Two value teach command sequence:
Buttons are found in menu: "Teach-in SSC1" or "Teach in SSC2" -> "Teach-in Two value SSC1"
or "Teach-in Two value SSC2"
1. Move the target (reflector) to the position for SP1 TP1
2. Move the target (reflector) to the position for SP1 TP2
3. Move the target (reflector) to the position for SP2 TP1
4. Move the target (reflector) to the position for SP2 TP2
5. Press Teach Apply
6. QoT is shown in "Quality of Teach" e.g. 100 %
2) Dynamic teach command sequence:
Buttons are found in menu: "Teach-in Dynamic SSC1" or "Teach-in Dynamic SSC2" -> "Teach-in"
1. Move the target (reflector) to the position for SP1
2. Move the target (reflector) to the position for SP2
3. Teach-in Result.Teach-in state = e.g. "SUCCESS"
4. QoT is shown in "Quality of Teach" e.g. 100 %
30
Rev.00 - 06.2021 | MAN PD30ETP/R IO-Link EN | © 2021 | CARLO GAVAZZI Industr6
A. Press "Teach SP1 TP1"
B. "Teash-in Result.TeachPoint 1 of Set Point 1" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP1 TP2"
B. "Teash-in Result.TeachPoint 2 of Set Point 1" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 TP1"
B. "Teash-in Result.TeachPoint 1of Set Point 2" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 TP2"
B. "Teash-in Result.TeachPoint 2 of Set Point 2" = e.g. "OK"
C. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Teach-in Result.Teach-in state = e.g. "Success"
Sensor
SSC
TP2
ON
A. Press "Teach SP1 Start ".
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP1 Stop "
D. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 Start ".
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP2 Stop "
D. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
SP2
SP1
TP1
TP2
TP1
OFF
Sensing distance

Publicité

Table des Matières
loading

Table des Matières