CARLO GAVAZZI IO-Link PD30ETP/R Serie Manuel D'instructions page 32

2) Dynamic teach command sequence:
Buttons are found in menu: "Teach-in SSC1" or "Teach-in SSC2" -> "Teach in Dynamic SSC1"
or "Teach in Dynamic SSC2"
1. Move the target (reflector) to the position for SP1
2. Move the target (reflector) to the position for SP2
3. QoT is shown in "Quality of Teach" e.g. 100 %
32
Rev.00 - 06.2021 | MAN PD30ETP/R IO-Link EN | © 2021 | CARLO GAVAZZI Industr6
A. Press "Teach SP1 Start"
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP1 Stop"
D. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
A. Press "Teach SP2 Start"
B. Teach-in Result.Teach-in state = e.g. "WAIT FOR COMMAND"
C. Press "Teach SP2 Stop"
D. Teach-in Result.Teach-in state = e.g. "SUCCESS"
Hyst
Sensor
SSC
SP2
TP2
OFF
Hyst
SP1
TP1
ON OFF
window
Sensing distance