Krick ro marin Dusseldorf Mode D'emploi page 41

1
Then holes of initially Ø 3 mm are drilled in the markings for the anchor tubes at the bow, for the stern tubes
in the corrugated trousers, for the 4 rudders and only if an extinguishing pump is provided for the suction
tube at the keel outlet. Before the corresponding parts are installed, they are then drilled out to fit.
Now make the markings for the deck support strips (2) for the main deck. With the help of the device shown
in the picture, the dimension 7.5 mm is set (e.g. 3x3 mm strip between pencil and wide strip and hold
together with adhesive tape) and applied from the upper edge of the hull inside all around.
In the area of the transition between the main deck and the foredeck, the marking must be continued
according to the plan with the aid of a ruler. The deck support strips are glued in later.
Rudder:
Drill the 4 holes for the rudder to Ø 4 mm at the stern. Remove the support blocks (4) and glue them to the
hull 35 mm below the upper edge of the hull (acrylite) after roughening the bonding area.
© Krick Modelltechnik, Knittlingen, Germany 5