Power Connection / Initial Channel Search - Sanyo DP26648 Manuel D'instructions

GETTING STARTED—POWER CONNECTION / CHANNEL SEARCH
POWER CONNECTION
5 Plug in AC power cord
(120V AC, 60 Hz).
6 Press the POWER key.
(Follow the on-screen
instructions.)
INITIAL CHANNEL SEARCH
Press the CHANNEL L (Up) key to search
7
for signals connected to the Antenna
terminal.
Channel Search will check for Antenna and
Cable signals. If Antenna signals are detected,
the HDTV searches for both analog and digital
off-air channels. If Cable signals are detected,
the HDTV will search for analog Cable channels.
Channels are stored in Channel Memory and
can be scanned using the CHANNEL L (Up)
and M (Down) keys.
If no Antenna signals are detected, the HDTV
will begin an AV search.
If neither of these searches detected a valid
signal, the HDTV will tune to input Video1.
INITIAL DISPLAY
To 120V AC outlet.
Need help?
Visit our Web site at
CHANNEL SEARCH DISPLAY
AV SEARCH
NOTE:Be sure all the external video devices you con-
nected to the HDTV are powered ON before
you begin an AV Search.
Press the CHANNEL M (Down) key to
8
search for signals from devices you con-
nected to the AV input jacks (Initial Display).
AV Search will begin checking the AV inputs for
valid signals, beginning with input Video1.
When a valid signal is detected, the search
process ends and the HDTV tunes to that input
source.
If a valid signal is not detected on any of the AV
inputs, the HDTV will tune to input Video1.
AV SIGNAL SEARCH DISPLAY
www.sanyoctv.com
1-800-877-5032
or Call
9