Getting Started (Required Initial Setup); Perform All Channel Search - Sanyo DP37647 Manuel D'instructions

GETTING STARTED
1
Install batteries in remote control (2AAA,
not included).
PRECAUTIONS
To ensure safe operation, please observe
the following precautions:
R
eplace both batteries at the same time. Do
not use a new battery with a used battery.
Risk of explosion, if battery is replaced by
an incorrect type.
Do not expose the Remote Control Unit to
heat.
moisture or
2
Connect Signal to the DTV's Integrated
Analog / Digital 75 ohm Antenna Input
terminal.
RF ANTENNA
OR
CABLE
OR
CABLE BOX OR SATELLITE BOX
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note: You must search for ClearQAM channels using
the "Digital Cable Search" menu option.
OR
3. The output from a VCR or cable box.
Digital signals can also be received through the
HDMI jacks.
Digital signals from a Set-top (STB) Box should be
received through the Video 1, 2, or 3, or HDMI Input1,
2, or 3 jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
(REQUIRED INITIAL SETUP)
Match the "+" and "–" signs on
the batteries with "+" and "–"
marks inside the remote control.
DTV ANALOG/
DIGITAL
ANTENNA IN
Need help?
Visit our Web site at
3
Plug in AC power cord
(120V AC, 60 Hz).
4
Press the POWER key. (Follow on-screen
instructions.)
5
Perform "All Channel Search." The All
Channel Search will search for off-air digital
and analog channels, and analog cable chan-
nels. The DTV can receive cable or off-air
channels, but not at the same time. If after
two searches
the DTV still
fails to detect
any channels,
the DTV will
tune to Video1.
ANALOG CHANNELS
Note: If EXIT is pressed,
the DTV will skip Channel
Search and tune to Video1
without storing any chan-
nels in the Channel Map
database.
www.sanyoctv.com
To 120 V AC outlet.
INITIAL ON-SCREEN
ALL CHANNEL SEARCH
DIGITAL CHANNELS
«
1-800-877-5032
or Call
5