AmazonBasics B07GF58DXB Mode D'emploi page 9

Installing hanger brackets
1. Starting from the left side of the door, measure in 2" (51 mm) and make a mark.
2. Measure down 1-1/2" (38 mm) and make a mark.
3. Take the hanger bracket and center the top hole over the line intersection.
4. Mark the bottom hole (making sure the center of the bottom hole is 2" (51 mm) away from the
door edge).
5. Remove the bracket and drill a 7/16" (11 mm) hole through the door for each bracket hole.
NOTICE
Door thickness will determine which bolt size to use.
6. Slide the washer (E3) over the screw (E1 or E2) and insert through the back of the door.
7. Slide the washer (E3) over the screw and screw on nut (E4), then hand-tighten.
8. Repeat steps 6 and 7 for the bottom hole.
9. Tighten down nuts.
10. Repeat for other side.
Installing anti-jump disk
1. Measure 2-7/16" (62 mm) from the inside of the hanger and make a mark in the center of the
door edge.
2. Screw the anti-jumper disc into the door top.
3. Do not tighten the anti-jumper disc all the way.
NOTICE
Prior to hanging the door, the anti-jump discs must be hanging over the front
edge of the door.
4. Repeat for other side.
D
/
E1 E2
E3
H2
H1
E4
9