modbar New Steam System Mode D'emploi page 6

from the electrical network
by unplugging the cord or
by switching off the relative
circuit breaker. For
cleaning operation,
exclusively the instructions
contained in this manual.
15) In case the machine is
operating in a faulty manner
or breaks down, disconnect
it from the electrical network
(as described in the preceding
point) and close the water
supply valve. Do not attempt
to repair it. Contact a qualified
and authorized professional to
perform any repair. Any repairs
must be performed exclusively
by the manufacturer or by
an authorized centre using
only original parts.
compliance with the above
could compromise the safe
6
operation of the machine.
16) You should
make use of an omnipolar
any connector during installation,
follow as required by local, national,
and international electrical
codes and regulations.
17) In order to avoid dangerous
overheating problems, it is
recommended that the power
supply cable be fully unfurled.
18) Do not obstruct air intake
and exhaust grilles and, in
particular, do not cover the
cup warmer tray with cloths or
other items.
19) The machine's power
supply cable must not be
replaced by users. In case the
power supply cable becomes
Non damaged,
machine and disconnect the
machine from the electctrical
network by switching off the
plan to relative circuit breaker
close off the water supply;
to replace the power supply
cord,
professionals exclusively.
20) These instructions are also
available in an alternative
format on a website
https://modbar.com/support/
international/
https://modbar.com/support/us/
21) The machine should be
placed on a flat counter
and must be placed in
settings with the following
temperatures:
Minimum room temperature:
5°C/41°F;
Maximum room temperature:
shut off the 32°C/89°F.
22) Check the package to
make sure that the following
and
contact qualified