NAD S100 Manuel D'installation page 7

Problem
NO SOUND
NO SOUND IN ONE CHANNEL
PROBLEM ON PHONO INPUT ONLY
WEAK BASS / POOR STEREO IMAGE
REMOTE CONTROL NOT WORKING
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Cause
• Power Mains cable unplugged or power
not switched on
• TAPE 1 MONITOR selected
• Mute on
• Connector to power amp not fitted correctly
• Internal fuse blown
• Power amp or active speaker
not switched on
• Connector to power amp not fitted correctly
• Input lead disconnected or damaged
• No signal
• Hum on Phono input
• Weak or Distorted signal
• Speakers connected to the power
amplifier wired out of phase
• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows
obstructed
Solution
• Check if AC Mains cable is plugged in and
power switched on
• De-select monitor mode
• Switch off Mute
• Check connections
• Consult dealer
• Switch power On
• Check connections
• Check leads and connections
• No phono amplification module installed
• Check MM, MC switch set correctly
Check phono earth lead is connected
• Check the turntable is connected to the
correct MM or MC phono input
• Check connections to all speakers in the
system
• Check or replace batteries
• Remove obstruction
GB
7