Yamaha RX-A870 Guide De Démarrage Rapide page 15

1
Turn on the subwoofer and set the volume to half.
If the crossover frequency is adjustable, set it to maximum.
VOLUME
MIN MAX
2
Place the YPAO microphone at your listening
position and connect it to the YPAO MIC jack on
the front panel.
The screen below appears on the TV.
Note
Place the YPAO microphone at your listening position (same height as your ears).
We recommend the use of a tripod as a microphone stand. You can use the tripod
screws to stabilize the microphone.
CROSSOVER/
HIGH CUT
MIN MAX
3
Use the cursor keys to select "Measure" and press
ENTER.
The measurement will start in 10 seconds.
It takes about 3 minutes to measure.
The screen below appears on the TV when the measurement finishes.
Note
If an error message (such as E-1) or warning message (such as W-2) appears,
see "Error messages" or "Warning messages" under "Optimizing the speaker
settings automatically (YPAO)" in the Owner's Manual.
4
Use the cursor keys to select "Save/Cancel" and
press ENTER.
5
Use the cursor keys to select "SAVE" and press
ENTER.
6
Use the cursor keys to select "YES" to enable
YPAO Volume and press ENTER.
7
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
15
En