FORGE ADOUR BASE 45 ACIER Mode D'emploi page 15

Precautions for use
It is recommended to wear protective gloves
when handling particularly hot components.
•The parts protected by the manufacturer
must not be handled by the user. None of
the gas line components are to be modified
by the user. The gas containers that can be
used on this type of appliance range from 6
to 13 Kg (Dimension, height: 560 mm and
depth: 310 mm max., pressure relief valve
included).
•Comply with the use-by dates of your hose,
and replace it if need be. Test the tightness
every time the hose is replaced.Check the
position of the connecting hose to ensure
that it is not in contact with the hot parts of
the appliance.
•Be sure to replace the container away from
any source of ignition.
•Do not plug the vents and regularly check
that they are clean. If the venturis are
clogged, contact the manufacturer or your
retailer.
•The underside of the appliance must remain
clear to allow for proper circulation of air to
the burner.
•Do not modify the appliance, contact the
manufacturer or your retailer.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
•Do not modify the appliance, contact the
manufacturer or your retailerin of doubt or
fault.
•Before using your FORGE ADOUR plancha
after a period of storage and/or inactivity,
check it carefully in order to detect any gas
leak and/or clogging of the burners.
•The following operation in particular are
considered wrong and dangerous use of the
appliance :
- Use of coal, wood or fuel other than liquid
gas butane, propane or their mixtures.
- Use of the plancha as heater.
Direction for use
LIGHTING AND OPERATION OF THE
Before lighting your plancha, check that all
the conditions stated in the "PRECAUTIONS
FOR USE" section are met.
• Check that the control switch is on the
« 0 » position as shown (Fig.1). Open the
gas supply.(bottle for Butane/Propane).
Control switch
• Rotate the control switch
counterclockwise while holding it down.
(Fig 2).
Control switch
• While still holdong the control switch
down, keep pressing on the ignition to
generate the sparks required for lighting
of the burners.
• Keep the control switch down for at least
5 seconds after lighting the burner. If
the burner has not ignited, stop acting on
the device, open the enclosure door and
/ or wait at least 1 min before attempting
to light the burner again.
15
PLANCHA
Piezzo
Piezzo