General Safety Information - Sebson IR OUT A Mode D'emploi

WEEE-Reg.-Nr. DE 78960174
Manual
Thank you for choosing a product of SEBSON. Please read the instructions carefully and keep them for looking up
before start-up this product. A long and failure-free operation can only be guaranteed if the installation and start-up
is done properly. Before starting up this product, please check for external damage. In case of visible external
damage we immediately dis-advise the start-up of this product! Please remove all packaging material of this product
before the first start-up an and check the content for completeness!
Intended use:
This SEBSON motion detector has an IR sensor that detects the heat radiation of moving objects and activates e.g.
a connected light.
Scope of delivery:
1 motion detector

 Screws for fixing (2 pieces)
Dowels Ø 6mm (2 pieces)


General safety information:

The installation of this product may be done only by a qualified person according the valid regulations for
Danger:
electrical installation!
If the power cables are damaged or come into contact with wetness, immediately disconnect the product
Danger:
from the power supply and ensure that it cannot be switched on again!
Danger of suffocation:
parts that can be swallowed!
Avoid overloading the device, an overload can damage the device or cause a short circuit! Therefore,
Caution:
please note the maximum power consumption in the technical data!
The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer

be guaranteed if it is modified! In addition, this will invalidate the warranty claim!
The manufacture does not accept any responsibility for injuries or damage resulting from improper use of

this product!
Any other use than the description may result in damage to the product. So the dangers are such as

electric shock, short circuit, fire etc.
We reserve the right to make changes to the product, the packaging or the operating instructions as well as

printing errors.
 This product is suited for indoor- and outdoor-use.
Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be

done by an expert and only by using original spare parts!
 In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Instruction for installation (Fig 5):
Before installing please make sure that the circuit is interrupted! For installation, the work on the mains
Danger:
voltage is required. Please remove the associated mains fuse or deactivate the switch fuse! Check by using a
voltage tester if the line is de-energized. Make sure that the current circuit will not closed during the installation!
Please keep this product away from children and animals. The packaging contains small
8