Zyxel NWA-3160 Mode D'emploi page 13

Make sure the screws are securely fixed to the wall and strong enough to
hold the weight of the ZyXEL Device with the connection cables.
2 Adjust the cables.
Run the connection cables down the back of the ZyXEL Device as shown in the following
figure.
OR:
Run the connection cables upward and along the edge of the ceiling.
3 Align the holes on the back
of the ZyXEL Device with
the screws on the wall.
Hang the ZyXEL Device on
the screws.
You can also use the optional Ceiling Mount Kit (sold separately) to mount
the ZyXEL Device on a ceiling instead of a wall.
5 Set Up Power over Ethernet (Optional)
Power over Ethernet (PoE) is the ability to provide power to your ZyXEL Device via an 8-
pin CAT 5 Ethernet cable, eliminating the need for a nearby power source.
ENGLISH
13