Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance and storage
– When the machine is stopped for servicing,
inspection, or storage, or to change an accessory,
switch off and remove the plug from the mains
supply and allow the machine to cool. Make sure
that all moving parts have come to a complete
stop before making any inspections, adjustments,
etc.
– Maintain the machine with care and keep it clean.
– Replace worn or damaged parts for safety. Ensure
all replacement parts are
TECHNIC
Approved.
– If an extension cord is used it shall not be of
lighter grade than the supply cord already fitted to
the machine.
– Check the supply and any extension cord
regularly for damage or signs of ageing.
Do not use the machine, if the cords are damaged.
– When servicing the cutter be aware that, even
though the motor will not start due to the interlock
feature of the guard, the cutter can still be moved
if the motor is turned by hand.
– Never attempt to override the interlock feature of
the guard.
Les matériaux d'emballage ne
sont pas des jouets ! Les enfants
ne doivent pas jouer avec des
sacs en plastique !
Il existe un risque de suffocation!
ELEM GARDEN
AVERTISSEMENT
ELEKTRISCHE VEILIGHEID
Controleer of de op het
typeplaatje van de machine
overeenkomt met de ter
INSTRUCTIONS FOR USE
_
Connect the appliance to a suitable extension
cord.
_
Feed the waste through the funnel.
Feed waste of a larger volume, e.g. thick branches,
through the wide part of the funnel.
_
Use the push stick for feeding the remaining parts.
_
End up feeding dry waste through the
appliance to remove moist waste.
_
Only switch off the appliance when all
waste has been shredded and the engine runs at no
load.
STARTING AND STOPPING
The blade continues to rotate
for a few seconds after the
machine is switched off.
Allow the motor/blade to stop
rotating before switching
Do not rapidly switch off and
_
To switch the appliance on, press the
on/off switch (6).
_
To switch the appliance off, press the
on/off switch again.
SHREDDING
In order to collect the shredded material, fasten the
carrying straps of the collecting bag (accessory) to
the two hooks while the shredder is switched off.
Feed the material to be shredded through the feed
intake.
vermelde spanning
plaatse beschikbare
netspanning.
"on" again.
on.
24
Publicité
Table des Matières
