Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
INSTANT POWER™ LOCATION
from the battery will corrode and damage the Instant Power™.
4.3
Do not operate the Instant Power™ in a closed-in area or restrict the ventilation in any way.
5.
DC CONNECTION PRECAUTIONS
5.1
Connect and disconnect the DC output clips only after setting all of the Instant Power™
switches to the "off" position (if applicable) and removing the AC plug from the electrical
outlet. Never allow the clips to touch each other.
5.2
Attach the clips to the battery and chassis, as indicated in the operating instructions.
6.
CHARGING AND AC POWER CORD CONNECTIONS
Pursuant to Canadian Regulations, use of an adapter plug is not allowed in Canada. Use
of an adapter plug in the United States is not recommended and should not be used.
7.
INSTALLATION INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the Instant Power™.
8.
FEATURES
1
2
8
13
17
12
11
15
19
RISk OF ELECTRIC SHOCk OR FIRE.
6.1
The Instant Power™ charger is for use on a nominal
120-volt circuit. The plug must be plugged into an outlet that
is properly installed and grounded in accordance with all local
codes and ordinances. The plug pins must fit the receptacle
(outlet). Do not use with an ungrounded system. NOTE:
4
3
5
6
7
9
10
14
18
RISk OF EXPLOSION AND CONTACT WITH
BATTERY ACID.
4.1
Locate the Instant Power™ as far away
from the battery as the DC cables permit.
4.2
Never place the Instant Power™
directly above the battery being jumped; gases
1.
Jump Start/USB On/Off Switch
2.
USB Port
3.
Built-In Work Light
4.
Digital Display
5.
Display Button
6.
Work Light On/Off Switch
7.
Inverter On/Off Switch
8.
12 Volt DC Outlets
9.
120 Volt AC Outlets
10.
Compressor Hose
11.
Compressor Gauge
12.
Compressor/Inflator Switch
13.
Inflator Port
14.
Charger Plug
16
15.
Wall Charger
16.
Battery Clamps
17.
Deflator Port
18.
Adapters
19.
Inflator Hose
3
•
•
Publicité
Table des Matières
